Плита минераловатная DoorHan «Вент Оптима»

DoorHan "VENT OPTIMA" mineral wool boards are used as a heat-insulating layer in the installation of facade structures with a ventilated gap in case of single-layer insulation and as an outer layer of heat-insulation when performing two-layer insulation.

Application:

Ventilated facade
Ventilated facade

Order with installation

Advantages

Hydrophobic impregnation of cotton wool forms a film on its surface, which prevents the penetration of liquid inside, while not blocking the natural circulation of air.

The raw material for the production of plates is natural stone. The products meet all the requirements for environmental friendliness, which is confirmed by the relevant certificates.

The excellent heat-insulating properties of mineral wool significantly reduce heat loss.

Allows to carry out installation of plates with the most dense prileganiye to each other.

Hydrophobic impregnation of cotton wool forms a film on its surface, which prevents the penetration of liquid inside, while not blocking the natural circulation of air.

The raw material for the production of plates is natural stone. The products meet all the requirements for environmental friendliness, which is confirmed by the relevant certificates.

The excellent heat-insulating properties of mineral wool significantly reduce heat loss.

Allows to carry out installation of plates with the most dense prileganiye to each other.

Technical description

Size Table

Specifications

Parameters

Value

Length, mm

1 200

Width, mm

600

Thickness, mm

from 50 to 250 in 10 mm increments

Packaging volume, m³

from 0.18 to 0.346 (depending on board thickness)

Parameter	Value	Notes
Density, kg/m³	75
Thermal conductivity, W/(m K), not more than at a temperature of 10 ˚С	λ10 = 0,035	at a temperature of 10 ˚С (283±1)K, no more
Thermal conductivity, W/(m K)	λ25 = 0,037	at a temperature of 25 ˚С (298±1)K, no more
Thermal conductivity, W/(m K)	λА = 0,038	calculated for operating conditions A and B according to SP 50-13330-2012, no more
Thermal conductivity, W/(m K)	λБ = 0,039	calculated for operating conditions A and B according to SP 50-13330-2012, no more
Compressive strength, kPa	5	for compression at 10% relative deformation, not less than
Tensile strength, kPa	5	when stretched perpendicular to the front surfaces, not less than
Water absorption, kg/sqm	1,0	with short-term partial immersion, no more
Content of organic substances, %	3,5	by weight, no more
Humidity, %	0,5	by weight, no more
Vapour permeability, mg/m·h·Pa	0,5	no more
Combustibility class according to European Standards	NG

Warranty print

If the consumer maintains the rules of transportation and storage, the warranty shelf life of the plates is six months from the date of manufacture.